The effects run on the different preset types. You can't currently make effects on the Control, Shapers and Video
preset types.
Effects are stored in the cues. When you need to stop an effects you need to "Stomp" the effect. Stomp is what we
use to tell the console to stop the effect on what ever we choose to stomp. This can be fixtures or preset types.
Off is as usually used to remove values from our programmer.
Effects are running in a cyclic loop. It changes between the High and Low values.
Usually you select some fixture, then you select what preset type you want the effects to run on and then press the
Effect key. Now you can choose some of the predefined effects.
You can have multiple effects running and if you need them to be in sync, then you can tap the Sync button.
If you want your effects to look more random, then you tap the Shuffle Selection button.
The following is a short description of the different values you can adjust.
Low / High value
The effects are mowing between two values. Called High and Low.
Speed
How fast your effect runs is defined by a speed parameter. This is measured in Beats Per Minute (BPM).
Phase
Phase is what could also be called distribution. This is where we can spread out the fixtures over the effect cycle.
If all your fixture have the same number in phase then they will all be at the same place in the cycle.
In this image there's 6 fixtures all at the green point in the sinus form:
To Next Page
Loading...
Need help?
General