5.62. Time key
Pressing the Time key opens the Time defaults window.
Using this window you can set the different times used when storing new cues.
If you are storing a cue and you have pressed the Store key, then the Time key will flash when you have set a
different default timing than the factory defaults.
Also when you are storing cues, you can temporary store a different time than your defaults using the Time key.
When using Time with Store you get the Fade Command.
Example
You want to store cue 2 with a fade time of 3 seconds. You press:
Store Cue 2 Time 3 Please
Notice that the command line is actually changing the time command into fade:
Store Cue 2 Fade 3
If you continue to press the Time key during the store operation, you can get to all the different possible timings in a
cue (except the preset type timings).
Store Cue 1 Time 2 Time 3 Time 4 Time 5 Time 6 Time 7
Gives you this in the command line:
Store Cue 1 Fade 2 OutFade 3 Delay 4 OutDelay 5 SnapPercent 6 CmdDelay 7
Related links
Time defaults window
Fade command
OutFade command
Delay command
OutDelay command
SnapPercent command
To Next Page
Loading...