Fade
Out Fade
Out Delay
Preset Type Timing
Cmd (Command)
Snap Percent
To edit the cells of the cue table, press and hold the cell. The corresponding edit window opens.
A selected cell in the cue table has blue background with a white frame around.
The current executed cue in the cue table has a green background.
The blue bar in the name column of a running cue displays the fade time from 0% to 100%.
Chaser
If the executor is set to a chaser, all cue functions and timings which are not active in the chaser mode are shown
gray out.
Additional is the chaser bar visible.
Forward (chaser direction mode):
Tap at to select the direction mode of the chaser.
There are four directions modes available
Forward
Backward
Bounce (e.g. starts with cue 1 to 4 and goes back from 4 to 1)
Random
Endless (chaser run mode):
Tap at to select the run mode of the chaser.
There are three run modes available.
Endless
Shoot-Off
The chaser starts at the selected cue, e.g cue 1, and stops at the end of cue 5. The executor is off after the last
cue.
Shoot-On
The chaser starts at the selected cue, e.g. cue 1, and stops at the end of cue 5. The executor is on after the last
cue.
Play:
Tap to start the chaser.
To Next Page
Loading...
Need help?
General