Tap to make this executor as a program time master.
The program time master controls the fade times of all program values and effects, between 0 and 10 seconds.
This affects both, the adding of new values into the programmer, and the removing of values from the programmer
with the Clear key.
Store Rate Executor:
Tap to make this executor as a rate master.
The rate master multiplies the cue timing and effect timing by a factor.
To leave the Empty Executor Window, tap Esc in the title bar or press Esc on the console.
Example Store Executor
Let´s assume, you will store the active programmer values as a cue on an executor 1.
1. Tap on the empty executor 1 in the executor bar window. The empty executor window opens.
2. Tap Store Executor 1 .
The active program values are stored on executor 1 as cue 1.
Example Group Executor
Let´s assume, you will store the selected left side dimmer fixtures as a group master on the empty executor 6.
1. Select all left side dimmer fixtures in the fixtures view.
2. Tap on the empty executor 6 in the executor bar window. The empty executor window opens.
3. Tap Store Group Executor 6 .
To Next Page
Loading...