Description
With the At command, you can
apply values to selected fixtures
apply presets to selected fixtures
apply a value from a fixture to another fixture
apply a value to an executor
use it as a helping command for e.g. a copy function
Syntax
1. Apply values to the selected fixtures:
At 50
2. Apply presets to selected fixtures:
At Preset 1.2
3. Apply a value from a fixture to another fixture:
Fixture 1 At Fixture 2
4. Apply a value to an executor.
Executor 1 At 50
5. Use the At command as a helping command for a e.g. a copy function.
Copy Cue 2 At 3
Example 1
Let´s assume, you will apply the dimmer value to 50 % to the selected fixtures.
At 5 0 Please
All selected fixtures have the dimmer value 50.
Double check the dimmer value in the Fixtures Sheet View.
If the master fader is not set to 100 %, the values in the Fixture Symbol View are smaller than in the
Fixture Sheet View.
Example 2
To Next Page
Loading...