7.11. CmdDelay Command
This page describes the syntax and how to use the CmdDelay command.
To go to the CmdDelay command it is necessary to press another function key before, e.g. Store and then six
times Time .
Description
With the CmdDelay command you set a cmd delay time.
Syntax
1. Store a new cue with a cmd delay time.
Store Cue 1 CmdDelay 4
2. Assign a cmd delay time to an existing cue.
Assign Cue 1 CmdDelay 4
Example 1
Let´s assume, you will store a new cue 1 on executor 4 with a cmd delay time of 2 seconds.
There are three ways to do this:
a) Press Store 1 (= Cue 1) Exec 4 six times Time (= CmdDelay) 2 Please .
b) Press Store 1 (= Cue 1) six times Time (= CmdDelay) 2 and press the respective executor button .
c) Press Store 1 (= Cue 1) six times Time (= CmdDelay) 2 and tap on executor 4 in the executor bar view.
Cue 1 is stored on executor 4 along with a cmd delay time of 2 seconds.
Example 2
Let´s assume, you have stored cue 1 on the main executor along with a command in column cmd (= Go Executor
6).
Now, you will that executor 6 starts with a delay time of 2 seconds.
Press + Label (= Assign ) 1 (= Cue 1) six times Time (= CmdDelay) 2 Please .
The command (= Go Executor 6) in cue 1 will start with a cmd delay time of 2 seconds after the go on cue 1 on the
main executor
Related Links
Time Key
Cues View
To Next Page
Loading...
Need help?
General