7.19. Edit Command
This page describes the syntax and how to use the Edit command.
To go to the Edit command press Edit on the console.
Description
With the Edit command, you can edit
open the cues view of an executor
cues
presets
groups
As long as you are in the edit mode, the Edit key is flashing.
To update the edited values, press Update Please .
To leave the edit mode, press Esc .
Syntax
1. Open the cues view of an executor.
Edit Executor 1
2. Edit a cue.
Edit Executor 1 Cue 2
3. Edit a preset.
Edit Preset 1
4. Edit a group.
Edit Group 1
Example 1
Let´s assume, you will open the cues view of executor 1 on screen 1.
There are two ways to do this:
a) Press Edit Exec 1 Please .
b) Press Edit and then the respective executor button .
To Next Page
Loading...