To Next Page

To Previous Page

dot2 User Manual

7.46. Preset Command

This page describes the syntax and how to use the preset command.

To go to the preset command, press Preset on the console.

Description

With the preset command, you can e.g.

label a preset

apply presets to fixtures

Syntax

1. Label a preset.

Label Preset 1

2. Apply a preset to a fixture.

Fixture 1 At Preset 1

Example 1

Let´s assume, you will label dimmer preset 1 as "close".

1. Open the dimmer presets pool.

2. a) Press Label Preset 1 Please .

2. b) Press Label and tap on preset 1 in the dimmer preset pool.

The Enter Name for Window opens.

Example 2

Let´s assume, you will apply color preset 2 (= red) to fixture 1.

There are two ways to do this:

a) Select fixture 1 in the fixtures view, open the color presets pool and tap on preset 2 (= red).

b) Press Fixture 1 At Preset 4 (= color presets pool) . 2 (= preset 2 red) Please .

Preset 2 from the color preset pool is applied at fixture 1.

MA dot2 User Manual

Other manuals for MA dot2