Example 3
Let´s assume, you will just open a preset type view at screen 1.
Repeat the steps from example 1 or 2 without selecting Presets in the view bar.
Related Links
Preset Key
MA Key
Preset Type Bar
How to work with Presets?
7.48. Preview Command
This page describes the syntax and how to use the preview command.
To go to the preview command, press Prvw on the console.
Preview is in the command line.
Description
With the Preview command you get a preview of the programmed output in the fixtures view and in the dot2 3D,
without having an actual DMX output.
You can use the Preview command for preview
executors
cues
If the console is in the preview mode, the Prvw key is blinking and the title bar of the fixtures sheet
changes into red.
To leave the preview mode, press Esc or Off Prvw on the console.
Syntax
1. To get a preview from an executor 102.
Preview ExecButton1 1.102
2. To get a preview from cue 1 on the main executor.
Preview Cue 1
Example 1
Let´s assume you will have a preview of the programmed executor 102 without having an actual DMX output.
To Next Page
Loading...