Added topics.
• Calibrating Reel Height Sensor (CLAAS 600 and
700 Series), page 258
• Adjusting Auto Reel Height (CLAAS 600 and 700
Series), page 260
Revised caution statement about reduced header
stability when cornering.
Towing the Header, page 291
• Removed mentions of discontinued flighting
bundles B6215 and B6216.
• Updated feed auger illustrations.
4.1 Float Module Feed Auger Configurations, page 307
Updated feed auger illustrations.
• 5.7.2 Checking Auger Drive Chain Tension, page
421
• 5.7.3 Adjusting Auger Drive Chain Tension, page
423
• 5.7.4 Removing Auger Drive Chain, page 424
• 5.7.5 Installing Auger Drive Chain, page 426
• Added changing oil in header drive gearbox (first 50
hours only).
• Added lubricating center draper roller bearings
(every 50 hours).
• Added checking draper roller bearings for heat
(every 200 hours)
5.3.1 Maintenance Schedule/Record, page 385
Added checking and adjusting finger timing
instructions.
• Checking Auger Finger Timing, page 434
• Adjusting Auger Finger Timing, page 435
Revised topic—No adjustment is required if spring
retainers are within +6 to –3 of flush and feed draper is
tracking properly.
5.10.2 Adjusting Feed Draper Tension, page 468
Updated torque value for center reel arm brace bolts.
Updated illustration to show new bolt orientation.
5.15.3 Centering Double Reel, page 507
Updated reel speed sensor illustrations.
• Replacing AGCO (Challenger, Gleaner, and
Massey Ferguson) Sensor, page 538
• Replacing John Deere Reel Speed Sensor, page
540
Updated load range D tire pressure to 75 psi.
5.17.3 Checking Tire Pressure, page 544
Added topics.
• 6.4.6 Center Skid Shoes Kit, page 554
• 6.5.9 European Combine Upper Cross Auger
(UCA), page 559
214683 viii Revision A
To Next Page
Loading...
