214683 189 Revision A
Figure 3.291: Calibration Wizard
4. The CALIBRATION WIZARD opens and displays a
hazard message warning screen.
5. Make sure to meet all the conditions listed on the
CALIBRATION WIZARD warning screen. Press the
green check mark to accept and start reel calibration.
Pressing the red X will cancel the calibration procedure.
Figure 3.292: Calibration Progress
6. A message appears in the CALIBRATION WIZARD
stating that reel calibration has started. The reel will
begin turning slowly and increase to high speed. A
progress bar is provided. If necessary, touch the red X
to cancel. Otherwise, wait for the message that reel
calibration has completed successfully. Touch the green
check mark to save the calibrated settings.
Setting up Automatic Header Controls (Gleaner S9 Series)
Automatic header functions are configured on the HEADER SETTINGS screen.
NOTE:
Changes may have been made to the combine controls or display since this document was published. Refer to the
combine operator’s manual for updates.
OPERATION
To Next Page
Loading...
