214683 71 Revision A
NOTE:
The following steps are only required if the above has not worked.
Figure 3.48: Torque Wrench
3. Remove the linkage cover. Refer to Removing Linkage
Covers, page 37.
4. Retrieve the supplied torque wrench (A) that is stored
on the float module frame on the right side.
Figure 3.49: Torque Wrench on Wing Nut
5. Place the torque wrench (A) on bolt (B) and use it to
move the wing until the lock disengages.
6. Replace the torque wrench (A) and reinstall the
linkage cover.
7. If necessary, balance the wing. Refer to 3.7.4 Checking
and Adjusting Header Wing Balance, page 73.
Operating in Rigid Mode
The three sections will be locked and operate as a rigid cutterbar.
Lock the wings as follows:
1. If the lock link does not engage, move the wing by raising and lowering the header, changing the header angle,
or driving the combine until it engages.
OPERATION
To Next Page
Loading...
