MacDon FlexDraper FD140 - Installing Feed Draper Idler Roller

214683 476 Revision A
1017124
A
B
D
C
Figure 5.165: Idler Roller
5. Remove nut (D) to have better access to the other two
nuts (C).
6. Remove two bolts (A) and nuts (C) from both ends of
the idler roller.
7. Remove the idler roller assembly (B).
Installing Feed Draper Idler Roller
1017126
A
B
C
Figure 5.166: Idler Roller
1. Position the idler roller assembly (B) in the float
module deck.
2. Install two bolts (A) and nuts (C) at both ends of the
idler roller.
NOTE:
Do NOT overtighten the bolts (A).
1013350
A
B
C
Figure 5.167: Idler Roller
3. Install nut (A).
IMPORTANT:
Maintain a 2–4 mm (1/16–3/16 in.) gap (C) between the
plate (B) and nut (A) to allow the idler roller to float and
to move when belt is tensioned or adjusted.
MAINTENANCE AND SERVICING