MacDon FlexDraper FD140 - Transport System (Optional); Checking Wheel Bolt Torque

214683 542 Revision A
5.17 Transport System (Optional)
Refer to 6.4.4 Stabilizer Wheels and Slow Speed Transport Package, page 553 for more information.
5.17.1 Checking Wheel Bolt Torque
If a transport system is installed, adhere to the following procedure for torquing the wheel bolts:
WARNING
To avoid bodily injury or death from unexpected startup of machine, always stop engine and remove key
before making adjustments to machine.
1. Turn off the engine and remove key.
1001277
2
3
4
5
6
1
Figure 5.308: Bolt Tightening Sequence
2. Follow the bolt tightening sequence shown, and torque
the wheel bolts to 110–120 Nm (80–90 lbf∙ft).
IMPORTANT:
Whenever a wheel is removed and reinstalled, check
the wheel bolt torque after one hour of operation and
every 100 hours thereafter.
MAINTENANCE AND SERVICING