214683 331 Revision A
4.2 Float Module Setup
The following sections outline the recommended float module setup guidelines for your specific combine model and
crop type; however, the recommendations cannot cover all conditions.
If feeding problems develop with the float module, refer to 7 Troubleshooting, page 561.
4.2.1 Using Auger Flighting
The auger flighting on the FM100 can be configured for specific combines and crop conditions. Refer to 4.1 Float
Module Feed Auger Configurations, page 307 for combine/crop specific configurations.
4.2.2 Using Stripper Bars
Stripper bar kits may have been supplied with your header to improve feeding in certain crops such as rice. They
are NOT recommended in cereal crops.
For servicing information, refer to 5.13 Float Module Stripper Bars and Feed Deflectors, page 482.
HEADER ATTACHMENT/DETACHMENT
To Next Page
Loading...
