MacDon FlexDraper FD140 - Adjusting the Header Height (Challenger and Massey Ferguson); Adjusting the Header Raise;Lower Rate (Challenger and Massey Ferguson)

214683 171 Revision A
Adjusting the Header Height (Challenger and Massey Ferguson)
Once the auto header height control (AHHC) is activated, press and release the HEADER LOWER button on the
control handle. The AHHC will automatically lower the header to the selected height setting.
NOTE:
Changes may have been made to the combine controls or display since this document was published. Refer to the
combine operator’s manual for updates.
1018169
A
Figure 3.260: Height Adjustment Knob on the
Combine Control Console
You can adjust the selected AHHC height using the
HEIGHT ADJUSTMENT knob (A) on the control console.
Turning the knob clockwise increases the selected height,
and turning the knob counterclockwise decreases the
selected height.
Adjusting the Header Raise/Lower Rate (Challenger and Massey Ferguson)
NOTE:
Changes may have been made to the combine controls or display since this document was published. Refer to the
combine operator’s manual for updates.
1019361
A
Figure 3.261: Challenger Combine Display
1. Press the Header icon (A) on the FIELD screen. The
HEADER screen displays.
OPERATION