MacDon FlexDraper FD140 - Page 265

214683 241 Revision A
1022802
A
Figure 3.413: John Deere S7 Console
10. Press button (A) on console to set engine to high idle.
1022810
Figure 3.414: John Deere S7 Display – Header
Calibration
11. Select START on calibration overview page.
12. Follow instructions that appear on combine display. As
you proceed through calibration process, display will
automatically update to show next step.
NOTE:
If an error code appears during calibration, sensor is out
of voltage range and will require adjustment. Refer to
Adjusting Voltage Limits: One-Sensor System, page
131.
1022828
Figure 3.415: John Deere S7 Display – Header
Calibration
13. When calibration is complete, select SAVE to confirm
calibration.
OPERATION