214683 442 Revision A
Figure 5.93: Upward Adjustment
1. Position tool (A) as shown, and pull up to adjust the
guard tips upwards.
Figure 5.94: Downward Adjustment
2. Position tool (A) as shown, and push down to adjust the
guard tips downwards.
NOTE:
If material is tough to cut, install stub guards with top
guard and adjuster plate. A kit is available from your
MacDon Dealer. Refer to 6.3.5 Stub Guard Conversion
Kit, page 550.
MAINTENANCE AND SERVICING
To Next Page
Loading...
