Crane operation
11.4 Operation of the rated capacity limiter
Operating manual 3 302 819 en 11 - 41
GMK3060
13.12.2018
Enter outrigger span (MAXbase)
The outrigger spans are entered as individual widths. If the Lifting capacity table
specifies an overall width then select the associated individual width.
If changing an outrigger span would result in an impermissible outrigger span,
then the selection is disabled for this outrigger beam. If necessary, you must
re-enter the outrigger spans in the sequence (1) to (4).
• Select and confirm the display (1) for the
desired outrigger beam.
• Select the rigged individual width (2),
e.g. 4.400 m (14.4 ft).
• Confirm the selection.
If the outrigger span measured by the outrigger
span monitoring differs from the entered value
then the value (3) is displayed in red.
The symbol (4) becomes grey – the rigging mode
cannot be adopted.
• In this case, rig the necessary outrigger span.
s
Overall width Individual width
6.200 m (20.3 ft) 3.100 m (10.2 ft)
4.400 m (14.4 ft) 2.200 m (7.2 ft)
2.320 m (7.6 ft) 1.160 m (3.8 ft)
To Next Page
Loading...
Need help?
General
