Crane operation
11.9 Heating and air-conditioning system
11 - 158 3 302 819 en Operating manual
GMK3060
13.12.2018
Setting the
heating period
After an automatic start, the heating system will switch off automatically as soon
as the set heating period has elapsed.
The heating period applies to all saved heating starts.
• Switch off the heating using the button (1).
• Press the button (2) for longer than 3 seconds.
The last set heating period, e.g. 27 minutes, now flashes for 5 seconds in the
display field.
• Set the desired heating period with the buttons (1) or (2). You can set a heating
period of 10 to 120 minutes.
Wait 5 seconds until the current time is displayed, e.g.14.00.
A new heating period has now been set.
Switching the
heating start on
and off
To switch on an automatic heating start, you must retrieve the corresponding stor-
age location.
• To retrieve a storage location, press the button (1) once.
The display field flashes for 5 seconds and a storage location is shown (e.g. 2).
The heating start at this storage location is now switched on.
To switch on a different heating start, press the button (1) repeatedly until the
desired storage location is displayed. This heating start is switched on as soon
as the display stops flashing.
To switch off the automatic heating start, press the button (1) repeatedly until a
storage location is no longer displayed.
To Next Page
Loading...
Need help?
General
