ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿
28 Parameter
917 Coulometer
ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿
251
[Note]
Entering a note on the calculation.
[Result variable]
Modifying the result variable.
[Result limits]
Defining the limits for the monitoring of the result.
[Result options]
Defining additional settings for the calculation.
Dialog "Edit calculation / Note"
In this dialog you can enter a short text, e.g. to describe the variables
used.
Dialog "Edit calculation / Result variable"
When a new calculation is created, the result variable will be automatically
issued. In this dialog, however, it can be modified at any time.
Result variable
To each calculation belongs an unambiguous result variable. With this
result variable you can use this result in additional calculations.
Selection R1 | R2 | R3 | R4 | R5 | R6 | R7 | R8 | R9
The selection contains only those result variables
which are not issued in this calculation command
yet.
Dialog "Edit calculation / Result limits"
For each result, limit values can be defined. These result limits are moni-
tored when the calculation is carried out. If monitoring is activated, the
results are shown as follows in the result display:
ï¿ Green, if the result falls within the limit values
ï¿ Red, if the result lies outside the limit values
Monitoring result limits
on | off (Default value: off)
Enabling and disabling the monitoring function.
Lower limit
When the monitored quantity falls below this value, the action defined in
the following is triggered.
Input range 0 - 9999999999
Default value 0
To Next Page
Loading...
Need help?
General
