28.5 Calculations
ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿
252
ï¿ï¿ï¿ï¿ï¿ï¿ï¿ï¿
917 Coulometer
Upper limit
When this value is exceeded, the action defined in the following is trig-
gered.
Input range 0 - 9999999999
Default value 9999999999
Action
Selection of the action, which is carried out when the result limits are
exceeded.
Selection Display message | Document message | Cancel
determination
Default value Display message
Display message
A message is displayed. You can select whether you want to continue
with the determination or cancel the run.
Document message
In the determination data it will be documented, that the result limits
have been exceeded.
Cancel determination
The determination is stopped.
Dialog "Edit calculation / Result options"
In the dialog Edit calculation / Result options, settings for how to pro-
cess the calculated result are defined.
Variable for mean value
If the statistic calculations have been activated (see method options), the
mean value of the single results will be saved as variable SMN1 to SMN9.
As default value, always the first free variable is being displayed.
Selection SMN1 … SMN9 | off
off
For the result not statistic calculations are carried out.
Save as common variable
on | off (Default value: off)
The calculated result can be saved as a method-independent variable, a
so-called common variable. The result is then also available in other meth-
ods for calculations. In all cases, only the single value will be saved, even if
the statistics function is enabled.
Variable
Selection of the common variable to which the result is being assigned.
To Next Page
Loading...
Need help?
General
