6 - 12 (00292)H
Trigger Input Selection Selects the connector where the external trigger signal is input.
TRIG1 Select when the trigger signal is input to the TRIG1 connector.
TRIG2 Select when the trigger signal is input to the TRIG2 connector.
Select when using the GX-HUB trigger connector.
ANY Selection items for the HX，GX-8 cameras.
Select when the trigger signal is input to either of the
TRIG1,TRIG2 connectors.
BOTH Selection items for the HX，GX-8 cameras.
Select when the trigger signal is input to both the
TRIG1,TRIG2 connectors and both signals are simultaneously
ON to identify the trigger.
TRIG1 Input Polarity Selects the external trigger signal (contact TTL level) polarity.
If TRIG1 is not used, select "Negative Polarity".
TRIG2 Input Polarity Selects the external trigger signal (current loop) polarity.
If TRIG2 is not used, select "Current ON".
TRIG1 Filter Specifies the external trigger signal noise filter effect to TRIG 1 in
microsecond units.
TRIG2 Filter Specifies the external trigger signal noise filter effect to TRIG 1 in
microsecond units.
Match the TRIG2 Filter to the TRIG1 Filter Settings
Match the TRIG2 filter settings to the TRIG1 filter settings.
Detect Trigger Edge
OFF（Level） Identifies the trigger when the trigger signal is enabled.
ON（Edge） Identifies the trigger when triggers signals changed from the
disabled status to the enabled status.
G trigger (Q camera) Function to detect trigger by G sensor, which is built in camera
and sensed by shock. By setting as “ON”, trigger signal is
generated by shock given to camera body, in addition to
standard trigger signal generated by user’s facility
G trigger level (Q camera)
Specify impact level to generate trigger signal.
The unit is [G] (acceleration).
Trigger Output Mode
Select trigger output mode and TRIG OUT output signal.
STATUS TRIG OUT signal indicates that trigger was detected.
TRIGOUT TRIG OUT signal is used as a recording trigger to cameras and
other instruments. Refer to page 8-25 for details.
Trigger Output Polarity
Select TRIG OUT output polarity.
ARM Status Output Polarity
Selects the ARM status signal polarity output by the camera.
ARM Command Input Polarity
Selects the ARM command signal polarity input to the camera.
If the ARM command is not used, select "Negative Polarity".
Select EST Input Select the external sync signals used from EST1/EST2.
To Next Page
Loading...