12 - 16 (00292)H
(3) Sequence to Save Together after Recording 3 Times
(Split the DRP segments into at least four parts in advance)
0 CSEG 1 Switch to memory segment number１
1 VIEW -1 Start VIEW
2 ARM -1 Start recording
3 WAITMODE STOP -1 Wait for the recording to end
4 CSEGINC NORMAL If recording on the next segment, switch segments
5 VIEW -1 Start VIEW
6 ARM -1 Start recording
7 WAITMODE STOP -1 Wait for the recording to end
8 CSEGINC NORMAL If recording on the next segment, switch segments
9 VIEW -1 Start VIEW
10 ARM -1 Start recording
11 WAITMODE STOP -1 Wait for the recording to end
12 UPDATE_DRIVE Confirm USB media
13 CSEG 1 Switch to memory segment number 1
14 SAVEFRMRANGE 0 TRIG -100 TRIG 100 Specify save range：Block 1 (※), -100~100
15 SAVE M1 Save frames -100~100 to the USB media
16 CSEGINC LOOP Forcibly switch to the next segment
17 SAVEFRMRANGE 0 TRIG -100 TRIG 100 Specify save range：Block 1 (※), -100~100
18 SAVE M1 Save frames -100~100 to the USB media
19 CSEGINC LOOP Forcibly switch to the next segment
20 SAVEFRMRANGE 0 TRIG -100 TRIG 100 Specify save range：Block 1 (※), -100~100
21 SAVE M1 Save frames -100~100 to the USB media
※ Specify the auto pilot parameter block numbers by subtracting 1 from the GX block number.
To Next Page
