(00292)H 4 - 21
Recordable Frames Number of frames that can be recorded.
(For display only. Settings cannot be changed.)
Custom Trigger Values Displays the number of recording frames before trigger input during
CUSTOM trigger timing.
(For display only. Settings cannot be changed.)
DRES Mode Dynamic range expansion shutter mode. Set with HX, GX cameras.
OFF Normal setting.
Sets the dynamic range to approximately 200%.
LOW Sets the dynamic range to approximately 400%.
MID Sets the dynamic range to approximately 800%.
HIGH Sets the dynamic range to approximately 1600%.
CUSTOM Refer to page 4-49.
Exposure Timing Used to match HX, GX, Q camera and fx camera exposure times.
Refer to page 4-41for details.
Pixel Bit Depth Pixel bit depth setting
(Can be set with HX, GX, Q camera. The bit depth to be set varies by
camera and DRP.)
8bit Sets the bit length to 8bit.
10bit Sets the bit length to 10bit.
12bit Sets the bit length to 12bit.
Black Balance Black balance ON/OFF setting. Set with HX, GX, Q camera.
Camera Synchronization
Select EST. Refer to page 6-4 for details.
Exposure Phase Specify the exposure phase shift with a value 0~359 (°).
Set with HX, GX, Q cameras. Refer to page 4-42 for details.
RGB Matrix Turns RGM matrix correction ON/OFF for the image data.
Set with HX, GX, Q cameras.
Luminance Properties Input/output transfer properties when image data is displayed
Set with HX, GX, Q cameras.
NORMAL Gain , Gamma , Knee used.
LINEAR Gain , Gamma , Knee settings ignored, data converted to linear for display.
CUSTOM Displays enhanced even for data with low luminance differences set to display
images with specific input/output transfer properties. Refer to page 5-14 for
details.
TABLE Function only for HX camera. Refer to page 5-15.
The following items are variable recording speed function items. (Only HX camera and GX-8)
Refer to page 4-43 for details.
Variable frame rate ON/OFF setting for variable recording speed function.
(Only indivisal)
Speed Ratio Setting specifying a low recording speed with the variable recording speed
function.
Speed ratio for high recording speed / low recording speed (2~100).
(Only indivisal)
High Recording Speed Frames
Frames recorded with the high recording speed.
(Only indivisal)
To Next Page