NEC DSX Software Manual

Conference
90 ◆ Features DSX Software Manual
Operation
Setting up a Conference
In these instructions:
[Super Display Soft Key]
[Keyset Soft Key]
To set up a Conference:
1.
Establish an Intercom or outside call.
2.
Press CONF.
• Your hear Intercom dial tone.
• Your caller hears Music on Hold (if installed) while they wait for you to set up the Conference.
3.
Do one of the following:
a.
Dial extension you want to add.
b.
Place or answer an outside call.
c.
Retrieve a call from Park Orbit.
4.
Press CONF to set up the Conference.
• If you cannot add additional parties to your Conference, you have exceeded the system’s Conference limit.
5.
Repeat steps 2-4 to add additional parties to your Conference. You can also do one of the following.
a.
To optionally place a Conference on Hold:
Press HOLD.
b.
To reinstate the Conference on Hold.
Press CONF.
Exiting a Conference
In these instructions:
[Super Display Soft Key]
[Keyset Soft Key]
To exit a Conference without affecting the other parties:
1.
Hang up.
• The remaining parties can continue their conversation uninterrupted.
• If you were in Conference with two outside lines, this may set up a tandem call. Refer to Tandem Calls /
Unsupervised Conference (page 341) for more.
Using Conference at a Single Line Telephone
In these instructions:
[Super Display Soft Key]
[Keyset Soft Key]
To use Conference at a single line telephone:
1.
Establish an Intercom or outside call.
2.
Hookflash and dial the extension or outside line you want to add.
3.
Hookflash and dial #10 to set up the Conference.
• If you cannot add additional parties to your Conference, you have exceeded the system’s Conference limit.
4.
Repeat steps 2 and 3 to add additional parties to your Conference.

NEC DSX Specifications