NEC DSX Software Manual

Meet-Me Conference
236 ◆ Features DSX Software Manual
Meet-Me Conference
Description
With Meet-Me Conference, an extension user can set up a telephone meeting with their co-workers. Each
party joins the Conference by dialing a Meet Me Conference code. Meet Me Conference lets extension users
have a telephone meeting — without leaving the office. Users must join the meeting within the Meet-Me
Conference interval.
The system has two Meet-Me Conference codes (#11 and #12). After a Meet-Me Conference is set up and
the Meet-Me Conference interval expires, the code used becomes available for a new meeting. Since Meet-
Me Conference is a type of Conference, the system’s Conference capacity determines:
❥ The number of users that can join a Meet-Me Conference, and
❥ The number of simultaneous conferences.
The following table shows the Conference capacities:
The system’s 32 Conference circuits are dynamically allocated as users request them.
Conditions
• None
Default Setting
• Meet-Me Conference enabled.
Programming
1. If yes, leave 1605-02: Meet Me Conference Join Timer (page 680) at its current setting.
2. If no, adjust 1605-02: Meet Me Conference Join Timer (page 680) as required.
Other Related Features
Features
The following features also allow different types of multiple party calls:
❥ Barge In (Intrusion) (page 36)
❥ Conference (page 89)
❥ Group Listen (page 187)
❥ Privacy (page 277)
❥ Tandem Calls / Unsupervised Conference (page 341)
Set up a multiple-party telephone conversation with your co-workers.
Description Capacity
Conference circuits 32
Maximum simultaneous users in Conference
(total of all Conferences system-wide)
32
Maximum simultaneous conferences 8
Maximum parties in any one Conference
(lines and/or extensions)
8
1.
After a co-worker hears a Page inviting them to join a Meet-Me Conference, do they have
enough time to join?

NEC DSX Specifications