NEC DSX - 2115-Hunting and Overflow Options; Sample Hunt Group Programming

21xx-Configuration
211x-Options
2115-Hunting and Overflow Options
DSX Software Manual Station Options: 2101-2501 ◆ 745
Station
2101-2501
2115-Hunting and Overflow Options
Description
Use this program to set the Extension Hunting and DID Intercept options for the extension (station).
If programming multiple extensions, you may find 9021-Station Copy (page 921) a handy time-saving tool.
Sample Hunt Group Programming
Circular Hunting
Terminal Hunting
Circular Hunting Programming (for 301, 303 and 304)
2115-01: Hunt Type Enter the same Hunt Type for all three extensions:
1 = Ring No Answer Line
2 = Busy/Ring No Answer Line
3 = Busy/Ring No Answer All Calls
4 = Busy Line
2115-01: Hunt Destination
301 303
303 304
304 301 (This causes hunting to loop back to 301)
1603-01: Transfer Recall Timer This timer sets how long an outside call waits at a busy member
extension. It also sets how long a call rings each member extension
as it cycles through the group.
1601-02: DIL No Answer Timer This timer sets how long a DIL rings its destination member exten-
sion before cycling through the group.
Terminal Hunting Programming (for 301 and 303)
2115-01: Hunt Type Enter the same Hunt Type for all three extensions:
1 = Ring No Answer Line
2 = Busy/Ring No Answer Line
3 = Busy/Ring No Answer All Calls
4 = Busy Line
2115-01: Hunt Destination
301 303
303 304
304 Press CLEAR to undefine entry. (Hunting stops at 304.)
1603-01: Transfer Recall Timer This timer sets how long an outside call waits at a busy member
extension. It also sets how long a call rings each member extension
as it cycles through the group.
1601-02: DIL No Answer Timer This timer sets how long a DIL rings its destination member exten-
sion before cycling through the group.