NEC DSX Software Manual

Account Codes
DSX Software Manual Features ◆ 17
Features
Programming Examples
1. In 1412-04: Forced Account Codes (page 651), enter Yes.
2. In 1412-06: Account Codes for Toll Calls Only (page 651), enter Yes.
3. In 1551-04: Account Code Toll Restriction Level (page 668), enter 2 (for example).
Make the following entries for Toll Restriction Level 2.
4. In 3511-01: Active Key Pad (page 840), enter Yes.
In 3512-04: Allow N11 Dialing (page 842), enter Yes.
In 3512-01: Allow 0 + XXX Operator Assisted Dialing (page 841), enter Yes.
In 3512-03: Allow 101x Equal Access Dialing (page 841), enter Yes.
5. In 352x-1010-XXX / Local XXX (Equal Access Dialing) (page 844), make a deny table with no entries
(i.e., deny nothing). This is the default setting.
6. In 353x-1+XXX / TBL-A XXX (NPA/NXX Dialing 3-Digit Table) (page 846), make a deny table and enter
900.
7. In 354x-1+XXX-XXX / TBL-A XXXXXXX (1 + NPA + NXX Dialing 6-Digit Table) (page 848), make a
deny table with no entries (i.e., deny nothing). This is the default entry.
8. In 355x-XXX / TBL-B-XXX (NPA/NXX Dialing 3-Digit Table) (page 850), make a deny table and enter
900.
9. In 356x-XXX-XXX / TBL-B XXXXXX (NPA + NXX Dialing 6-Digit Table) (page 852), make a deny table
with no entries (i.e., deny nothing). This is the default setting.
10. In 2102-01: Class of Service (page 724), assign the Class of Service with Forced Account Codes enabled
to the extension.
11. In 2102-02: Station Toll Level (Day) (page 724) and 2102-03: Station Toll Level (Night) (page 724), be
sure the extension does not use Toll Level 2. If it does, Toll Restriction will always deny 1 + 900 and 900
calls (regardless of whether the user enters an Account Code).
With this programming, an extension user can:
1. Press a line key or dial a code for an outside line.
2. Wait for a reminder tone (3 beeps).
• With Forced Account Codes enabled, the system automatically goes into the Account Code mode after
you press a line key in step 1 above.
• If you have an Account Code Feature Key, it flashes green.
3. If dialing a 1 + 900 or 900 call, dial the Account Code.
If dialing any other long distance call, skip this step.
4. Press # (if enabled), the Account Code soft key, or an Account Code Feature Key (if programmed).
5. Dial the outside number.
• If the user doesn’t enter an Account Code for 900 or 1 + 900 calls, the system will cut off the call.
• The system will also cut off any call not allowed by the extension’s Toll Restriction programming.
1. Forced Account Codes Require an Account Code only for 900 and 1 + 900 Long Distance Calls.

NEC DSX Specifications