NEC DSX Software Manual

42xx-IntraMail
423x-Dial Actions (Dial Action Table Options)
4231-Digit Assignment
DSX Software Manual Voice Mail Options: 4101-4231 ◆ 905
Voice Mail
4101-4231
Dial Action Table Actions
STRF Action - Screened Transfer (1)
(STRF)
Use this action to allow an Automated Attendant caller to place a Screened Transfer to an extension. After an
Automated Attendant caller dials an extension, IntraMail calls (screens) the destination to see if the transfer
can go through.
❥ If the destination is available, the Automated Attendant rings it. If the destination answers, the call goes
through.
❥ If the destination doesn’t answer within a preset interval, is busy, or is in Do Not Disturb, the Automated
Attendant doesn’t extend the call. It then provides the caller with additional options.
Routing
Normally, the corresponding Routing option should be XXX. Note that the key you choose for this action is
the first digit of the called extension number.
• For example, to allow callers to place Screened Transfers to extensions 300-399, for key 3 enter STRF
for the Action and XXX for the corresponding Routing.
To have Screened Transfer call a specific extension, the corresponding Routing option should be that exten-
sion’s number. The caller then dials that single digit to reach the extension.
• For example, to have caller’s dial 8 to reach extension 303, for key 8 enter STRF for the Action and
303 for the corresponding Routing.
F
eatures
• None
IntraMail Features
• Screened Transfer (page 567) and Screened Transfer (STRF) Operation (page 568)
• Unscreened Transfer (page 587)
Options for Action
• 1 for STRF
Options for Routing
• Digits using 0-8, # and * (8 max.)
• N for no routing (press Feature Key 1)
• I for ignore caller dialed digit (press Feature Key 2)
• X for caller dialed digit (press Feature Key 3)
• P for pause (press Feature Key 4)
Default
• See the Dial Action Table Default Settings (page 902).

NEC DSX Specifications