NEC DSX Software Manual

31xx-Configuration
310x-Setup
3103-Settings
816 ◆ Line Options: 3101-3714 DSX Software Manual
3103-04: Tandem Calls
(Tandem Calls)
Use this option to enable or disable Tandem Calls for the line.
Enable Tandem Calls for lines if Off Premises Call Forwarding should be able to route incoming calls to an
off-premises location. The originating line (i.e., the line that Off Premises Call Forwarding will reroute)
must have this option enabled. If enabled, the system can forward an incoming over a second line to an off-
premise number. If disabled, line-to-line forwarding cannot occur. This option is not required when the sys-
tem is forwarding Intercom calls off-premises. When this option is disabled (N), the system will immediately
route a line ringing an OPX Call Forwarded extension to Key Ring. It will not attempt to reroute the call.
Features
• Call Forwarding Off Premises (page 51)
• Tandem Calls / Unsupervised Conference (page 341)
IntraMail Features
• Centrex Transfer (page 460)
• External Transfer (page 483)
• Make Call (page 525)
Options
• No (0) - Disabled
• Yes (1) - Enabled
Default
• No (0) - Disabled
3103-05: Music On Hold Source
(MOH Source)
Use this option to assign the Music on Hold music source.
Features
• Music on Hold (page 246)
IntraMail Features
• Message On Hold (page 541)
Options
• 0 for none.
•
1 for audio input minijack 1.
• 2 for audio input minijack 2.
• 3 for internal tone 1.
• 4 for internal tone 2.
• 5 for IntraMail Message On Hold. See Message On Hold (page 541) for more.
Default
•

NEC DSX Specifications