NEC DSX Software Manual

Account Codes
18 ◆ Features DSX Software Manual
1. In 1412-04: Forced Account Codes (page 651), enter Yes.
2. In 1412-06: Account Codes for Toll Calls Only (page 651), enter Yes.
3. In 1551-04: Account Code Toll Restriction Level (page 668), enter 2 (for example).
Make the following entries for Toll Restriction Level 2.
4. In 3511-01: Active Key Pad (page 840), enter Yes.
In 3512-04: Allow N11 Dialing (page 842), enter Yes.
In 3512-01: Allow 0 + XXX Operator Assisted Dialing (page 841), enter Yes.
In 3512-03: Allow 101x Equal Access Dialing (page 841), enter Yes.
5. In 352x-1010-XXX / Local XXX (Equal Access Dialing) (page 844), make a deny table with no entries
(i.e., deny nothing). This is the default setting.
6. In 353x-1+XXX / TBL-A XXX (NPA/NXX Dialing 3-Digit Table) (page 846), make an allow table and
enter 800.
7. In 354x-1+XXX-XXX / TBL-A XXXXXXX (1 + NPA + NXX Dialing 6-Digit Table) (page 848), make a
deny table with no entries (i.e., deny nothing). This is the default entry.
8. In 355x-XXX / TBL-B-XXX (NPA/NXX Dialing 3-Digit Table) (page 850), make an allow table and enter
800.
9. In 356x-XXX-XXX / TBL-B XXXXXX (NPA + NXX Dialing 6-Digit Table) (page 852), make a deny table
with no entries (i.e., deny nothing). This is the default setting.
10. In 2102-01: Class of Service (page 724), assign the Class of Service with Forced Account Codes enabled
to the extension.
With this programming, an extension user can:
1. Press a line key or dial a code for an outside line.
2. Wait for a reminder tone (3 beeps).
• With Forced Account Codes enabled, the system automatically goes into the Account Code mode after
you press a line key in step 1 above.
• If you have an Account Code Feature Key, it flashes green.
3. If dialing a 1 + 800 or 800 call, skip this step.
If dialing any other long distance call, dial the Account Code.
4. Press # (if enabled), the Account Code soft key, or an Account Code Feature Key (if programmed).
5. Dial the outside number.
• The call will go through without an Account Code. If the user doesn’t enter an Account Code for all
other calls, the system will cut off the call.
• The system will also cut off any call not allowed by the extension’s Toll Restriction programming.
2. Forced Account Codes Allow 800 and 1 + 800 Long Distance Dialing without an Account Code.

NEC DSX Specifications