NEC DSX - Page 280

Names for Extensions and Lines
250 ◆ Features DSX Software Manual
❥ 2201-01: Ring Group Name (page 779)
❥ 2301-01: UCD Group Name (page 790)
❥ 2501-[01-16]: Selectable Display Messages (page 806)
❥ 3101-02: Line Name (page 810)
❥ 4111-01: Voice Mail Port Name (page 865)
❥ 904x-Backup/Restore (page 927)
Other Related Features
See list under Description above.
Operation
Programming Names
In these instructions:
[Super Display Soft Key]
[Keyset Soft Key]
To program your extension’s name:
• If you have access level 4 or 5, use “To program a name for a co-worker’s extension . . .” below instead.
1.
[Menu + Name]
[Menu + MORE + MORE + Name]
Select name programming.
2.
Follow the instructions in the Name Programming Chart below.
3.
Press HOLD + SPEAKER to exit.
To program a name for a co-worker’s extension, a Ring Group, or a UCD Group:
1.
[Menu + Name]
[Menu + MORE + MORE + Name]
Select name programming.
2.
When you see EXT:xxx, do one of the following.
a.
Enter the name of the extension you want to program + HOLD.
b.
Press HOLD to accept the displayed name.
c.
Enter the master number for the Ring Group you want to program + HOLD.
d.
Enter the master number for the UCD Group you want to program + HOLD.
3.
Follow the instructions in the Name Programming Chart below.
4.
Do one of the following.
a.
Press HOLD to back up to step 2 and program another name.
b.
Press HOLD + SPEAKER to exit.