NEC DSX Software Manual

Night Service / Night Ring
254 ◆ Features DSX Software Manual
Other Related Features
Features
Direct Inward Line (page 109)
• The extension to which the DIL is terminated controls the night mode of the DIL.
• If a DIL is terminated to the voice mail master number, a UCD night key (code 18 + the voice mail
master number) controls the night mode status of the DIL.
Direct Station Selection (DSS) Console (page 120)
A DSS Console with a System night key can put the system in the night mode.
Do Not Disturb (page 143)
A DIL destination activates the night mode for the DIL when they press DND.
Group Ring (page 189)
The System night key sets the day/night status of a DIL terminated to a Ring Group.
Paging (page 259)
To have lines ring the External Paging system, see Outside Call Ringing Over External Page
(page 260) . To have the ringing call also activate the system relay, see Page Relay Control (page 259)
IntraMail Features
None
Operation
Using Night Service / Night Ring
In these instructions:
[Super Display Soft Key]
[Keyset Soft Key]
To activate or deactivate Night Service (i.e., to control the night mode of Key Ring and Ring Group lines):
1.
Do not lift the handset.
2.
Press your System night key.
• While in the night mode, the key is on (red) and you see: SYSTEM IN NIGHT MODE.
• While in the day mode, the key is off.
To answer a call that rings a line or loop key at night:
1.
Listen for ringing and look for the flashing line or loop key.
• Line and loop keys that flash red are for you and your co-workers.
• Line keys that flash green are just for you (such as DILs and transfers).
2.
Lift the handset.
3.
Press the flashing line or loop key.
• If you have Ringing Line Preference, lifting the handset answers the call.
• If you have Automatic Handsfree, you can press the line or loop key without first lifting the handset.
To answer a call that is ringing over the Paging speakers:
1.
Lift the handset.
2.
Dial *0.

NEC DSX Specifications