NEC DSX Software Manual

Reverse Voice Over
DSX Software Manual Features ◆ 291
Features
Operation
Using Reverse Voice Over
In these instructions:
[Super Display Soft Key]
[Keyset Soft Key]
To place a call using Reverse Voice Over:
1.
While on a handset call, press and hold your Reverse Voice Over key.
• You hear two beeps, then you can talk to your co-worker.
• The key lights red as you press it.
To return to your initial caller:
1.
Release your Reverse Voice Over key.
• The key goes out.
To place a call to your Reverse Voice Over partner:
1.
While your telephone is idle, press your Reverse Voice Over key.
• You hear two beeps, then you can talk to your co-worker. (Optionally lift handset for privacy.)
• The key lights green.
To Transfer a call using your Reverse Voice Over key:
1.
While on a call, press TRANSFER.
2.
Press your Reverse Voice Over key.
3.
Do one of the following.
a.
• Announce the call to make a Screened Transfer.
• Hang up.
b.
Press the flashing line key to return to the call if your co-worker doesn’t want it.
c.
Hang up to send the call through unscreened.
• The call will recall to you if unanswered at the destination. If you don’t answer the recall, it
diverts to Key Ring.

NEC DSX Specifications