NEC DSX Software Manual

Speed Dial
320 ◆ Features DSX Software Manual
b.
Enter the Line Group number you want the system to use when dialing your stored number (90-98).
c.
Press INTERCOM if you want to enter Intercom codes.
6.
Press HOLD.
7.
Enter the number you want to store (up to 32 digits long).
• If storing Intercom codes, you can enter a valid dial sequence using the digits 0-9, #, and *.
• To insert a pause, press
MUTE. To insert a Flash, press FLASH.
• Do not enter a pause or flash into an Intercom code.
8.
Press HOLD twice.
9.
Enter a name for the Speed Dial number.
• See Name Programming Chart (page 322) for more.
10.
Press HOLD.
11.
Do one of the following.
a.
Repeat from step 3 to program another bin.
b.
Press SPEAKER to exit.
To dial a stored Personal Speed Dial number:
1.
Do one of the following.
a.
Press INTERCOM, dial #, then dial the Personal Speed Dial bin number (701-720).
b.
24-Button or 34-Button Telephone Only
Press bin key for bins 701-710.
c.
Press a Feature Key set up as a Personal Speed Dial key.
d.
Super Display Telephone Only
• Press Spd Dial 1 (bins 701-710) or Spd Dial 2 (bins 711-720).
• Press the soft key for the number you want to dial.
2.
(Optional)
• To chain bins, wait for the first bin to dial out, then press a bin key or Feature Key.
• If the programmed route is busy, press an idle line key to reroute the call.
• You cannot chain Intercom numbers.
Programming and Dialing System Speed Dial
In these instructions:
[Super Display Soft Key]
[Keyset Soft Key]
Forced Account Codes may prevent Speed Dial from dialing 911 emergency services.
To program a System Speed Dial number:
1.
Do not lift the handset or press any keys.
2.
Dial #SP (#77).
3.
Dial the System Speed Dial bin number (normally 201-299).
4.
Press HOLD.
5.
Do one of the following.
Programming and Dialing Personal Speed Dial
In these instructions:
[Super Display Soft Key]
[Keyset Soft Key]

NEC DSX Specifications