NEC DSX Software Manual

90xx-Utilities
902x-Copy
9022-Line Copy
924 ◆ Maintenance Options: 9001-9211 DSX Software Manual
Using 9022-01: Line Copy
To copy data from a line to another line or range of lines:
1.
Access option 9022-01. You see: Copy Program
2.
Press HOLD and select the option (01-12) corresponding to the line program you want to copy.
• You can dial the option number (01-23) or press Volume Up and Volume Down to scroll through the selections.
3.
Press HOLD. You see: From Line
4.
Enter the source line number + HOLD. You see: To Line
• This is the line from which the data will be copied.
5.
Enter the target line number + HOLD. You see: Thru Line
• This is the line to which the data will be copied.
• If you are copying data to a range of lines, this is the first (lowest) line in the range.
6.
Do one of the following.
a.
If copying data to a single line, re-enter the line you entered in step 5 above + HOLD.
b.
If copying data to a range of lines, enter the highest (last) line in the range + HOLD.
7.
When the copy has successfully completed, you see: Copy Complete

NEC DSX Specifications