2 - 264 Memory Blocks
___________________________________________________________________________________
___________________________________________________________________________________
Document Revison 1 Elite IPK
1-11-06 Signaling Selection
General Description
Use this Memory Block to specify Loop Start (LS) or Ground Start (GS) Trunk
Signaling when using T1.
Display
Settings
Notes
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8 The shaded
selection is the
default.
LS GS
Programming Procedures
1 Go off-line.
2 Press LK1 + LK11 +
KF
to access the Memory Block.
3 Press the corresponding CO/PBX line key to change the data option.
4 Press
G
to write data and advance to the next Channel No.
5 Repeat Steps 3 and 4 for each Channel No. The next Memory Block is displayed.
6 Program the next Memory Block or press
E
to go back on-line.
Related Programming
M.B. Number Memory Block Name
1-11-07
DTI Trunk Type Assignment
7-1
Card Interface Slot Assignment
The DTI-U( ) ETU must be assigned in the system to set this Memory Block.
System Mode
1
Submode
11
Data No.
06
PC Programming
¦
+AD
Channel
No.
0 1 / 0 6 : T R N K 0 1 = L S
T I M E D I S P L A Y
Data
No.
Setting
Data
DTI No.
(01~08)
Title
To Next Page
Loading...
