NEC Electra Elite IPK - Page 336

Elite IPK Document Revision 1
Programming Manual 2 - 265
___________________________________________________________________________________
___________________________________________________________________________________
1-11-07 DTI Trunk Type Assignment
General Description
Use this Memory Block to assign the trunk type (CO/E&M Tie line/DID/ANI) four
channels at a time. Assignment to an individual channel is impossible.
Display
Settings
LK 1 LK 2 LK 3 LK 4 LK 6 LK 7 LK 7 LK 8 The shaded
selection is the
default.
CO E&M DID ANI
Programming Procedures
1 Go off-line.
2 Press LK1 + LK11 +
KG
to access the Memory Block.
3 Press the corresponding CO/PBX line key to change the data option.

Use dial pad keys to change DTI Number (01~08).
4 Press
G
to write the data. The next Memory Block is displayed.
5 Program the next Memory Block or press
E
to go back on-line.
System Mode
1
Submode
11
Data No.
07
PC Programming
¦ +AD
0 1 / 0 7 : T R K ( 1 ) C O
T I M E D I S P L A Y
Data
No.
Setting
Data
DTI No.
(01~08)
Title
Block
No.
1~6
Block
No.
4-Channel Unit
DTI
No. 1
DTI
No. 2
DTI
No. 3
1 01~04 25~28 49~52
2 05~08 29~32 53~56
3 09~12 33~36 57~60
4 13~16 37~40 61~64
5 17~20 41~44 N/A
6 21~24 45~48 N/A