2 - 266 Memory Blocks
___________________________________________________________________________________
___________________________________________________________________________________
Document Revison 1 Elite IPK
Notes
Related Programming
M.B. Number Memory Block Name
1-11-06
Signaling Selection
7-1
Card Interface Slot Assignment
1. A DTI-U( ) ETU must be assigned in the system to set this Memory Block.
2. When the default setting is changed to E&M or DID, the affected trunks are automatically reassigned to Trunk
Group 00. When trunks 01 ~ 08 are affected, default line key assignment for all Multiline Terminals changes to
Not Used and must also be reassigned. Memory Block 3-14 resets to second dial.
To Next Page
Loading...
