NEC Electra Elite IPK - Page 493

2 - 422 Programming Manual
___________________________________________________________________________________
Document Revison 1 Elite IPK
___________________________________________________________________________________
3-38 Automated Attendant Message to
Trunk Selection
General Description
Use this Memory Block to assign the Automated Attendant Message for each CO/PBX
Trunk. When the Automated Attendant Message is assigned to each CO/PBX Trunk,
the system automatically answers the incoming call and sends an Automated
Attendant Message to the calling party.
Display

Notes

Programming Procedures
1 Go off-line.
2 Press LK3 +
G
+
CH
to access the Memory Block.
3 Enter data for CO/PBX No. using the dial pad to change the Automated Attendant
message number.
Setting Data: 1~8 Automated Attendant Message 1~8

Use the following to enter data:
J
to moves the cursor left
L
to moves the cursor right
K
~
I
to enter numeric data or CO/PBX No.
– OR –
D
to go to the next assigned CO/PBX Line No.
Default Values
Message 1
4 Press
G
to write the data and display the next Memory Block.
5 Program the next Memory Block or press
E
to go back on-line.
An Access Code must be dialed from the attendant telephone position to activate this feature.
CO/PBX Line Mod
e
3
Submode
—
Data No.
38
PC Programming
¦ +AU
0 1 / 3 8 : A A M S G = 1
T I M E D I S P L A Y
Data
No.
Setting
Data
CO/PBX
No.
(01~64)
Title