1 - 28 Multiline Terminal Programming
___________________________________________________________________________________
___________________________________________________________________________________
Document Revison 1 Elite IPK
07 K-CCIS Message Response
Timeout Assignment
30 sec
Valid Times: 01~99 Seconds
08 Link Reconnect Allow/Deny
Selection
YS
NO, YS
09 K-CCIS Maximum Call Forwarding
Hop Assignment
5
1~7
10 Calling Name display Allow/Deny
Selection
NO
NO, YS
11 Centralized Billing Allow/Deny
Selection
NO (Deny) NO (Deny), YS (Allow)
12 Centralized Billing – Point Code of
Center Office Assignment
Blank
Point Code Range: 00001~16367
13 Centralized Day/Night Switching for
Remote Office Assignment
NO (Deny) NO (Deny), YS (Allow)
14 Centralized Day/Night Switching for
Main Office Assignment
All Tables Not
Specified
Table Range: 01~16
Point Code Range: 00001~16367
LK 1 System Mode
LK 15 K-CCIS (Continued)
Data
No.
Memory Block Name Default Value Programming Values
LK 1 System Mode
LK 16 HUB
Data
No.
Memory Block Name Default Value Programming Values
00 Auto Negotiation Yes/No Selection YS (Enable)
YS, NO
01 Port Speed Selection – 10/100
Base-T
100 (100 Base-TX)
10 (10 Base-T), 100
(100 Base-TX)
02 Port Duplex Mode Selection HALF
HALF, FULL
03 MDI/MDIX Mode Selection AUTO
MDIX, MDI, AUTO
04 VLAN Mode Selection NO (Disable)
NO, YS (Enable)
05 Default VLAN ID Assignment 0001 (0x001 Hex.) 0001~4095 (0x001~0xfff Hex.)
06 Port Based Priority Selection NO (Not Assigned)
NO, LO (Low), HI (High)
To Next Page
Loading...
