NEC Electra Elite IPK - Page 60

Elite IPK Document Revision 1
Programming Manual 1 - 29
___________________________________________________________________________________
___________________________________________________________________________________
07 High Priority RX Tag Assignment 7
(Lowest) 0~7 (Highest)
08 High Priority TX Tag Assignment 7
(Lowest) 0~7 (Highest)
09 Low Priority TX Tag Assignment 0
(Lowest) 0~7 (Highest)
10 Port Mirroring Selection NO (Normal)
NO, YS (Mirror)
11 Mirroring Source Port Assignment Port 1
Port range: 1~8
12 Mirroring Target Port Assignment Port 1
Port range: 1~8
13 VLAN Group to VLAN ID
Assignment
0001(0x001)
ID Range:
0001~4095 (0x001~0xfff
Hex.)
14 VLAN Group and Port Selection NO
NO, YS
15 VLAN Tag Insertion Selection NO
NO, YS
16 Flow Control for Full Duplex
Selection
NO
NO, YS
17 Back Pressure for Half Duplex NO
NO, YS
LK 1 System Mode
LK 16 HUB (Continued)
Data
No.
Memory Block Name Default Value Programming Values
LK 2 Tenant Mode
Data
No.
Memory Block Name Default Value Programming Values
01 Trunk to Tenant Assignment
Refer to 2-01 Trunk to Tenant Assignment on page 2-369.
05 Line Key Selection TEL
TEL (Telephone Mode)
TNAT (Tenant-Wide Mode)
06 Line Key Selection for Tenant Mode
Refer to 2-06 Line Key Selection for Tenant Mode on page 2-372.
07 System Speed Dial Display
Assignment
CO/PBX Line LED
On
All Speed Dial
Confirmation Allowed
On (Assigned)
Off (Not Assigned)
08 ECR Relay to Tenant Assignment All Tenants - No
Assignment
N/A
09 DID Limit to Tenant Assignment 00
00 (no limit), 01~64 Incoming Calls