Elite IPK Document Revision 1
Programming Manual 3 - 39
___________________________________________________________________________________
___________________________________________________________________________________
3.4 Call by Call (CBC) Programming (LCR PC Software V2.0 or Higher)
3.4.1 The International/Operator Table
This table has a page for each LCR Class (1~4) that contains fixed
dialing patterns that can be assigned to that Class.
H
Two routes can be assigned and arranged in priority. PRT
should have higher priority.
H
Trunk Group or Route Advance Blocks are specified in TG/
RAB.
H
Delete digits specifies the number of digits to delete from the
first dial when using PRT.
H
PreDigits controls whether digits that are specified in pre-digit
tables are dialed before the International or Operator code.
H
When TG/RAB is not assigned, outgoing calls cannot be made.
3.4.2 The OCC Table
This Table has 16 pages (called Table 1~Table 16) that are required
for each of the LCR Classes for a total of 64 tables with fixed dialing
patterns.
H
Dial means following the OCC dial.
H
Two routes can be assigned and arranged in priority. PRT
should have higher priority.
International or Operator Table Example
LCR Class
1~4
Dial Priority TG/RAB
Delete
Digits
PreDigits
Add/Not Add
Class1
0-
1
RAB 09 1 Not Add
2 None None Not Add
00
1
RAB 10
2Not Add
2 None None Not Add
010
1
RAB 11
3Not Add
2 None None Not Add
011
1
RAB 12
3Not Add
2 None None Not Add
01N
1
RAB 13
2Not Add
2 None None Not Add
ON
1
RAB 14
1Not Add
(N = 2~9) 2 None None Not Add
To Next Page
Loading...
