Elite IPK Document Revision 1
Programming Manual 2 - 21
___________________________________________________________________________________
___________________________________________________________________________________
3
Press the corresponding CO/PBX line key to change the tenant number.
Use the following to enter data:
J
to move the cursor left
L
to move the cursor right
K
~
I
to enter numeric data
C
to move to the next page
A
to move to the previous page
Each time a CO/PBX line key is pressed, the LED toggles between On and Off.
Default Values
All System Speed Dial buffers can
be dialed from any tenant.
4 Enter all pages for the selected buffer, and press
G
to write the data and display the next Speed Dial Buffer No.
5 After entering data for the last Speed Dial Buffer No., press
G
to write that data, and the next Memory Block is displayed.
6
Program the next Memory Block or press
E
to go back on-line.
Related Programming
M.B. Number Memory Block Name
1-1-33
Speed Dial Number/Name Display Selection
1-1-35
Speed Dial Buffer Allocation
2-01
Trunk to Tenant Assignment
4-09
Telephone to Tenant Assignment
Programming Procedures
Speed Dial buffers have the nine groups listed in the table below.
Speed Dial
Buffer No.
Speed Dial Number
80 Codes 1000 Codes
0X 00~09 000~099
1X 10~19 100~199
6X 60~69 600~699
7X 70~79 700~799
8X N/A 800~899
~
~
~
X = 0~9
CO/PBX
Line LED
Off
On
Data Restricted
Not Restricted
The shaded area indicates
the default setting.
To Next Page
Loading...
