Additional Information
Operation in Error Reset is shown below.
Note that you must reset errors only after the axis has stopped. Do not reset errors during axis
motion.
If you clear the error for this instruction, the instruction will not start until Execute changes to
TRUE again.
16#0000
Execute
Busy
Active
Done
CommandAborted
Error
ErrorID
Error reset.
Error code
Ver. 1.10 or Later
Error Codes
Refer to the NY
-series Troubleshooting Manual (Cat. No. W564) for instruction errors.
3 Axis Command Instructions
3-148
NY-series Motion Control Instructions Reference Manual (W561)
To Next Page
Loading...
Need help?
General
