Additional Information
Operation in Error Reset is shown below.
Note that you must reset errors only after the axis has stopped. Do not reset errors during axis
motion.
•
If you clear the error for this instruction, the instruction will not start until Execute changes to
TRUE again.
16#0000
Execute
Busy
Active
Done
CommandAborted
Error
ErrorID
Error reset.
Error code
Ver. 1.10 or Later
Error Codes
Refer to the NY
-series Troubleshooting Manual (Cat. No. W564) for instruction errors.
4 Axes Group Instructions
4-81
NY-series Motion Control Instructions Reference Manual (W561)
MC_GroupStop
4
Function
To Next Page
Loading...
