Parker 590+ series - Page 296

C-6 Parameter Specification Tables
DC590+ Series DC Digital Drive
Tag Mn MMI Block Name MMI Parameter Name Minimum Maximum Default Units Range Notes
113 d5 RAMPS RAMPING 0 1 0 V1 W4
114 d6 SEQUENCING SEQ STATE 0 15 0
0: SEQ INIT
1: SEQ INIT
2: SEQ HOLD
3: SEQ STANDBY
4: SEQ PRE READY
5: SEQ READY
6: SEQ AUTOTUNING
7: SEQ RUN
8: SEQ AT ZERO SPD.
9: SEQ QUENCH
10: SEQ PROGRAM STOP
11: SEQ STOP
12: SEQ DELAY STOP
13: SEQ COAST STOP
14: SEQ ERROR
15: CURRENT DECAY
V0 W4
115 d7 ALARMS HEALTH WORD 0x0000 0xFFFF 0x0000 V1 W4
116 d8 ALARMS HEALTH STORE 0x0000 0xFFFF 0x0000 V1 W4
118 da RAMPS RAMP HOLD 0 1 0
0: OFF
1: ON
V1 W0
119 db CURRENT LOOP I DMD. ISOLATE 0 1 0
0: DISABLED
1: ENABLED
V1 W0
120 dc MENUS ENTER PASSWORD 0x0000 0xFFFF 0x04D2 V0 W0
121 dd MENUS CHANGE PASSWORD 0x0000 0xFFFF 0x0000 V1 W0
122 de ALARMS HEALTH LED 0 1 0 V0 W4
125 dh SEQUENCING READY 0 1 0 V0 W4
126 di MIN SPEED MIN SPEED 0.00 100.00 0.00 % V1 W0
128 dk AUX I/O ANOUT 1 -100.00 100.00 0.00 % V0 W0
129 dl AUX I/O ANOUT 2 -100.00 100.00 0.00 % V0 W0
130 dm COMMS PORT 3 MODE 0 4 3
0: DISABLED
1: 5703 MASTER
2: 5703 SLAVE
3: EIASCII
4: EIBINARY
V0 W0
131 dn DEADBAND DEADBAND WIDTH 0.0 100.0 0.0 % V0 W0
132 do 5703 IN SETPT. RATIO -3.0000 3.0000 0.0000 V0 W0