Setting Description
Password Specify a password that contains 1 to 16 characters
from any of the following groups:
• Letters: A to Z, a to z
• Numbers: 0 to 9
• Special characters: . - _ ~ ! @ # $ % ^ & ( ) { }
• Doesn't start or end with a space.
Port Specify a port number to access the RTRR server.
Upload limit Specify an upload rate limit for the RTRR server.
• Unlimited: No limit is set.
• Maximum: Specify a maximum limit.
Download limit Specify a download rate limit for the RTRR server.
• Unlimited: No limit is set.
• Maximum: Specify a maximum limit.
Use TCP BBR congestion control Optimizes transmission speeds allowing for higher
bandwidth and lower latency
4. Optional: Configure Network Access Approval.
a. Select Allow approved connections.
Note
If no IP addresses are added, all connections are allowed.
The Approved Connections table appears.
b. Click Add. The Add IP Address window opens.
c. Select an IP address version.
d. Specify an IP address or IP address & subnet mask.
e. Select an access privilege.
f. Click Add.
5. Click Apply.
Disabling the RTRR Server
1. Open HBS 3.
2. Go to Services > RTRR Server .
3.
Click
.
HBS 3 disables the RTRR server.
QTS 4.5.x User Guide
Hybrid Backup Sync 380
To Next Page
Loading...
Need help?
General
