QNAP QTS 4.5 Series User Manual

Authentication Method Description
Selected Users/Groups Administrators can grant access to specific QTS
users or groups. A QTS username and password is
required to access files.
Tip
To grant access to domain users, first
set up Domain Security. Go to Control
Panel > Privilege > Domain Security .
6. Click Apply.
Wi-Fi
This screen controls the configuration and management of Wi-Fi connections accessible from the NAS.
Important
• A USB or PCIe Wi-Fi device must be installed to access these features.
• For a list of compatible USB Wi-Fi dongles, visit http://www.qnap.com/
compatibility, then select Search by Devices > USB Wi-Fi .
• For a list of compatible PCIe Wi-Fi cards, visit http://www.qnap.com/compatibility,
then select Search by Devices > Expansion Card > QNAP .
• QTS supports the simultaneous use of multiple PCIe Wi-Fi cards, but only one USB
Wi-Fi dongle can be in used at a time.
QTS 4.5.x User Guide
Network & Virtual Switch 413

QNAP QTS 4.5 Series Specifications

General

Operating System	QTS 4.5 (Based on Linux)
File System	EXT4
Supported RAID Levels	RAID 0, RAID 1, RAID 5, RAID 6, RAID 10, JBOD, Single
Networking Protocols	TCP/IP, IPv4, IPv6, SMB, NFS, AFP, FTP, SFTP, HTTP, HTTPS, iSCSI
Management Interface	Web-based GUI
Supported Protocols	SMB/CIFS, NFS, FTP, SFTP, WebDAV, AFP, iSCSI
Snapshot Support	Yes
Virtualization Support	Yes
Backup Solutions	Hybrid Backup Sync
Security Features	AES 256-bit encryption, Antivirus, IP Blocking
Mobile Apps	Qfile, Qmanager, Qphoto, Qmusic, Qvideo, Qnotes, Qcontactz
Maximum Storage Capacity	Varies by model. Dependent on the number of drive bays and the maximum capacity of individual drives supported.